Barix RackBox Intercom

The RackBox is an IP based intercom station for any to all communication over the local or wide area network. Its setup consists of an unlimited number of 19’’ rack mountable RackBoxes, a message routing device (AudioSpread) and a web based management server. The source can be limited to act as receiver or sender. Multi source set ups are possible.

The system is designed to be maintenance free, low power (15W) and long lasting. If additional features are requested, the device is ready to receive updates through the management server or an USB stick. The interface provides a graphical overview of the system on a map, as well as showing a status list to monitor station changes onsite.

Technical Specifications

Operation System


• Embedded Linux



Network Interfaces


• 1 x Ethernet (RJ45) Interface
• IPv4, IPv6 capable
• 10/100 fdx/hdx, auto negotiation



Audio Interface


• 1W RMS Internal Speaker
• 1 x XLR Microphone Input with pre-amplification
• Phantom Power on Microphone
• Balanced in/out interface on screw terminal block, 0dBu level



Audio Formats


• uLaw 24KHz Audio Codec sent as an RTP stream



USB


• Doube USB connector type A female



CPU / Memory


• Barix IPAM400 Processor Module
• Quad-Core ARM Cortex™ -A7
• 256MByte DDR3 SDRAM
• 16MB SPI Flash
• 8GB SD-Card Flash



Hardware Interface


• 1 x Push Button
• 2 x Multicolor LED Status indicators
• Reset & Factory Defaults Button
• 1 x Volume Control
• Relay output



Power Requirements


• 125-230VAC 15W 50-60Hz



Measurement / Mechanics


• 19” x 8.66” x 1,97” / 480mm x 220mm x 50mm



Weight


• 1520g

Environmental

Operating Environment


• 0°C to + 50°/ 32 to 122°F environmental
• 0 -70% relative humidity, non-condensing



Storage Conditions


• -20 to +70°C / -4 to 158°F0 -70% relative humidity, non-condensing



Certifications


• FCC and CE